jjrest.blogg.se - Kerio connect appliance

#Kerio connect appliance install#
#Kerio connect appliance windows#

In case of VNC server, the following additional configuration is required: Remote Desktop server, to enable remote access to the server. Helpful tool for testing connectivity to a network socket and issuing commands.ĭNS Domain Name System - Enables the translation of hostnames to IP addresses and provides other domain related information.

#Kerio connect appliance install#

You can use the Synaptics program from the graphical desktop of your server to install these tools, or you can do so from a command line as follows: Program In order to minimize the size of this Virtual Appliance, there are some helpful debugging tools that are not part of the operating system and you may need to install them manually.

comes with CentOS as an operating system. With Kerio Connect 7.2.x and earlier, the Kerio Virtual Appliance Pre-configured Kerio Connect virtual machine image for VMware. If you are using Debian, refer to this topic instead. The output from this clearly displays the linux type. You can use the following command: sb_release -a However, you must add the new drive to /etc/fstab so that it is mounted automatically when the server reboots.This information is provided 'As Is' and Kerio Technical Support will not be able to help you further if you have any problems.įirst ensure that you are running the CentOS variant of Linux. Check the drive is mounted - ls -lsa /store.Įverything is now up and running.

Mount the drive: mkdir /store (to create a directory for the drive), mount -t ext3 /dev/sdb1 /store (to mount the drive to this directory).

This commands formats the partition with the ext3 filesystem which should work fine for your Debian system.

Format the new disk: mkfs.ext3 /dev/sdb1.

Your new partition is created at /dev/sdb1. From the menus at the bottom select the following: The cfdisk controller will load up and here you can create a new partition on your drive.

Create a new partition on your new drive: cfdisk /dev/sdb.

The disk at /dev/sdb is picked up and there are no partitions.

To check whether Debian installed and picked up your new hard drive, run the following command: fdisk -l.

Using your VM Hypervisor, add a new hard drive to your VM and start the appliance.

To increase available disk space for the message store, you can add a second virtual hard disk to the appliance.

Some of these commands are potentially destructive and may cause damage to your system if not carried out correctly.

- the Kerberos realm used in your Active Directoryįor information on importing users from Active Directory, read this article.Run the following command on your Kerio Connect console: kinit - the appliance hostname and corresponds to the computer name in the Active Directory

#Kerio connect appliance windows#

Run the following command on your Windows Active Directory (master): setspn.exe -R hostname Add the Service Principal Name for the computer to the Kerberos database.If you set up a wrong hostname, change the following configuration files: /etc/hostname and /etc/hosts. Use the same hostname as defined in the appliance (run hostname -f to display the hostname). Add new computer to your Active Directory.In the Kerberos 5 configuration wizard, configure the Kerberos realm and domain server hostname.For Kerio Connect 8.5 and older, install the following packages: apt-get install krb5-clients krb5-config